Maximum motor supply current: 2A per motor.Perfect for driving DC and Stepper motors for micro mouse, line-following robots, robot arms, etc. This motor driver is perfect for robotics and mechatronics projects and perfect for controlling motors from microcontrollers, switches, relays, etc. It can control up to 4 DC motors, or 2 DC motors with directional and speed control. It uses the popular L298 motor driver IC and has an onboard 5V regulator which it can supply to an external circuit. The PWM Pins are unnecessary if you do not want to control PWM features.L298N 2A Based Motor Driver is a high power motor driver perfect for driving DC Motors and Stepper Motors.Make sure you have all of your grounds tied together Arduino, Power source, and the Motor Controller.H-bridges are typically used in controlling motors’ speed and direction but can be used for other projects such as driving the brightness of certain lighting projects such as high powered LED arrays.EnA: Enables PWM signal for Motor A (Please see the “Arduino Sketch Considerations” section).5v: 5v input (unnecessary if your power source is 7v-35v, if the power source is 7v-35v then it can act as a 5v out).The L298N module has a very famous L298 Motor driver IC which is the main. Out4: Mo (Can actually be from 5v-35v, just marked as 12v) 5A 2-Way PWM Speed Dual H-Bridge Stepper Motor Driver L298N on Alitools price.L298N DC Motor Driver Module Robot Dual H Bridge for Arduino PIC AVR. Logical ”0” input voltage up to 1.5 v (High Noise Immunity) Pre-assembled L298N Dual Motor Driver Board, with Led indicators, an on board +5V.Total DC current up to 4amp (Each channel can carry up to 2amp).Perfect for driving DC and Stepper motors for micro mouse, line following robots, robot arms, etc. This motor driver is perfect for robotics and mechatronics projects and perfect for controlling motors from microcontrollers, switches, relays, etc. An additional supply input is provided so that the logic works at the lower level. Specifications Of L298 Motor Driver H Bridge Module: Double H Bridge Drive Chip: L298N Logical Voltage: 5V Drive Voltage: 5V-35V Logical Current: 0-36mA. Alternatively, the module is capable of driving a single 4 input stepper motor. This driver allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino.
Two enable inputs are provided to enable or disable the device independently of the input signals. The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors. High working power to 46v,large current can reach 3A MAX and continue current is 2A, power to 25w. Low heat,outstanding anti-interference performance. L98 Motor Driver Board is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepper motors. L298N as main chip, ST corporation production. IMU, Accelerometer, Magnetometer & Gyroscope Sensor.